A summary of the steps used to configure the LUNs, or logical volumes, on the StorEdge T3+ arrays in your StorEdge 3900 or 6900 system is listed below.
If you are using the menu-driven interface, perform the following steps.
On the storage service processor (SSP), start the Configuration Utilities using the runsecfg command.
Select T3+ Configuration Utility from the main menu.
Enter your StorEdge T3+ array password when you are prompted.
Step through the submenus to configure the StorEdge T3+ arrays. See the Sun StorEdge 3900 and 6900 Series Reference Manual for more information about the submenus.
If you are using the command-line interface, perform the following steps.
On the SSP, enter your StorEdge T3+ array password (if prompted to do so).
Use the SSP StorEdge T3+ array commands to configure the arrays in your system. See the Sun StorEdge 3900 and 6900 Series Reference Manual and the man pages for these commands for more information.