How to Configure the Sun Cluster Device Group That Is Controlled by Hitachi TrueCopy

Before You Begin

If you are using storage-based replication, do not configure a replicated volume as a quorum device. The Sun Cluster Geographic Edition software does not support Hitachi TrueCopy S-VOL and Command Device as a Sun Cluster quorum device. See Using Storage-Based Data Replication in Sun Cluster 3.0-3.1 Hardware Administration Manual for Solaris OS for more information.

Steps

1. Register the VERITAS Volume Manager disk group that you configured in the previous procedure.

   Use the Sun Cluster commands, scsetup or scconf.

   For more information about these commands, refer to the scsetup(1M) or the scconf(1M) man page.

2. Synchronize the VERITAS Volume Manager configuration with Sun Cluster software, again by using the scsetup or scconf commands.

3. After configuration is complete, verify the disk group registration.

   # scstat -D

   The VERITAS Volume Manager disk group, oradg1, should be displayed in the output.

   For more information about the scstat command, see the scstat(1M) man page.