What to Do

1. Disconnect the diskette data cable (if present) from the top of the UltraSCSI backplane at connector J0502.

   Figure 7-2  

   
   

2. Disconnect the removable media power cable from the UltraSCSI backplane at connector J0104.

3. Disconnect the removable media SCSI cable from the top of the UltraSCSI backplane at connector J0501.

   Leave all other cabling connected to the rear of the drives in the removable media assembly.

4. At the front of the system, pull off the plastic cover from the front of the removable media assembly.

   Grasp the cover on both sides, and pull it away from the front of the system.

5. Loosen the two captive Phillips screws securing the removable media assembly to the chassis.

   Figure 7-3  

   
   

6. Slide the removable media assembly out of the system chassis.

   Be sure that you feed all the cables carefully out of the RMA chassis opening as you remove the assembly.

   ---

   Note -

   At this point all the power and data cables are attached to the rear of the drives installed in the assembly.

   ---

   Figure 7-4  

   
   

7. Place the assembly on an antistatic mat.