What to Do

1. Install the appropriate metal filler panel into any empty RMA drive bay opening.

   Align the two metal retainer clips in the front of the drive bay, and press the filler panel into place.

2. Grasp any cables attached to the rear of the removable media devices and feed them into the RMA opening at the front of the chassis.

   Hold the removable media assembly in one hand and use the other hand to feed the cables into the opening.

3. Slide the removable media assembly into the system chassis.

   Make sure that the cables are not caught between the removable media assembly and the chassis as you slide the assembly into the chassis.

   Figure 7-6  

   
   

4. Tighten the two captive Phillips screws securing the removable media assembly to the system chassis.

   Figure 7-7  

   
   

5. If necessary, install one or more plastic filler panels in any empty drive bay openings in the RMA plastic cover.

   Align the filler panel with its opening and press it into place.

6. Replace the RMA plastic cover.

   Align the two posts on the cover with the corresponding holes at the front of the chassis and press the cover evenly on both sides until it snaps into place.

7. Connect the removable media SCSI cable to the UltraSCSI backplane at connector J0501.

   Each connector is keyed so that it connects in only one way.

8. If applicable, connect the diskette data cable to the SCSI backplane at connector J0502.

9. Connect the removable media power cable to the UltraSCSI backplane at connector J0104.

   Figure 7-8