Internal Access

The system has a front bezel that must be removed to access the media tray.

Front Bezel

To remove the front bezel:

1. Grasp the front bezel on both sides near the center.

   Place your thumbs on top of the front bezel and place your other fingers at the slight indentations under the front bezel for leverage.

2. Pull the front bezel straight out toward you and set it aside.

   Press down on the top of the bezel as you pull it toward you. See Figure 12-1.

   Figure 12-1 Removing the Front Bezel

   
   

To replace the front bezel, reverse these instructions.

Media Tray

To access the media tray:

1. Remove the front bezel. See "Front Bezel".

2. Loosen the two captive screws securing the media tray in the chassis.

3. Insert a screwdriver or similar instrument in the notch at the bottom center of the tray. Using the screwdriver, slightly pull out the tray. See Figure 12-2.

4. Grasp the media tray and gently pull it from the chassis.

   Disconnect the cables from the back of the tray.

5. To access the devices in the media tray, turn the tray over and place it upside down on top of the E3500 cabinet.

6. Loosen the four screws securing the drive to the media tray and remove the drive.

   Figure 12-2 Removing the Media Tray

   
   

To replace the media tray, reverse these procedures.