Dynamic Reconfiguration on Sun Fire High-End Systems

This section describes major domain-side DR bugs on the following Sun Fire high-end systems that run the Solaris 10 software:

• Sun Fire 25K

• Sun Fire 20K

• Sun Fire 15K

• Sun Fire 12K

For information about DR bugs on Sun Management Services, see the SMS Release Notes for the SMS version that is running on your system.

Known Software and Hardware Bugs

The following software and hardware bugs apply to Sun Fire high-end systems.

Deleteboard Shows Leakage Error (4730142)

Warnings might be displayed when a DR command is executing on a system that is configured with the SunSwift PCI card, Option 1032. These warnings appear on domains that are running either the Solaris 8, Solaris 9, or Solaris 10 software. The following warning is an example:

Aug 12 12:27:41 machine genunix: WARNING:
 vmem_destroy('pcisch2_dvma'): leaked

These warnings are benign. The Direct Virtual Memory Access (DVMA) space is properly refreshed during the DR operation. No true kernel memory leak occurs.

Workaround: To prevent the warning from being displayed, add the following line to /etc/system:

set pcisch:pci_preserve_iommu_tsb=0

GigaSwift Ethernet MMF Link Fails With CISCO 4003 Switch After DR Attach

The link fails between a system with a Sun GigaSwift Ethernet MMF Option X1151A and certain CISCO switches. The failure occurs when you attempt to run a DR operation on such a system that is attached to one of the following switches:

• CISCO WS-c4003 switch (f/w: WS-C4003 Software, Version NmpSW: 4.4(1))

• CISCO WS-c4003 switch (f/w: WS-C4003 Software, Version NmpSW: 7.1(2))

• CISCO WS-c5500 switch (f/w: WS-C5500 Software, Version McpSW: 4.2(1) and NmpSW: 4.2(1))

This problem is not seen on a CISCO 6509 switch.

Workaround: Use another switch. Alternatively, you can consult Cisco for a patch for the listed switches.