Use this procedure to install and configure the BroadVision One-To-One Enterprise software and how to enable the BroadVision One-To-One Enterprise software to run in the Sun Cluster environment.
Follow the guidelines that are listed in Planning the Sun Cluster HA for BroadVision One-To-One Enterprise Installation and Configuration and Configuration Considerations.
Follow the instructions in the BroadVision One-To-One Enterprise Installation and Administration Guide to install the BroadVision One-To-One Enterprise software on the cluster file system.
Install the BroadVision One-To-One Enterprise software only once, on the cluster file system, from any cluster node.
Configure the $BV1TO1_VAR/etc/bv1to1.conf file.
Table 1–3 summarizes possible configurations in the $BV1TO1_VAR/etc/bv1to1.conf file for the BroadVision One-To-One Enterprise components. See Standard Data Service Configurations and the instructions in the BroadVision One-To-One Enterprise Installation and Administration Guide for details.
Table 1–3 Configuring the $BV1TO1_VAR/etc/bv1to1.conf File
If you configure the Interaction Managers on all of the cluster private hostnames, set up the HTTP servers on the same cluster. Alternatively, if you configure the Interaction Managers on all of the cluster nodes, the HTTP servers can be set up outside of the cluster.
Configure your cluster so that BroadVision One-To-One Enterprise back-end servers can access the database from any cluster node.
Depending on the flexibility and granularity of administration that you require for each back-end resource, you can set up your failover resource groups in one of the following ways.
Set up multiple failover resource groups to use multiple logical hostnames. If you plan to use this option, go to How to Verify the Sun Cluster HA for BroadVision One-To-One Enterprise Installation and Configuration.
Set up one failover resource group to use n logical hostnames and to contain all of the back-end and root host resources. If you plan to use this option, proceed to Alternative Configuration and follow the procedures in that section to complete the installation.
See Standard Data Service Configurations for more information.