Perform this procedure to verify that the cluster is successfully upgraded to Sun Cluster 3.2 1/09 software. On the Solaris 10 OS, perform all steps from the global zone only.
Ensure that all upgrade procedures are completed for all cluster nodes that you are upgrading.
Ensure that all steps in How to Commit the Upgraded Cluster to Sun Cluster 3.2 1/09 Software are completed successfully.
On each node, become superuser.
On each upgraded node, view the installed levels of Sun Cluster software.
phys-schost# clnode show-rev -v |
The first line of output states which version of Sun Cluster software the node is running. This version should match the version that you just upgraded to.
From any node, verify that all upgraded cluster nodes are running in cluster mode (Online).
phys-schost# clnode status |
See the clnode(1CL) man page for more information about displaying cluster status.
SPARC: If you upgraded from Solaris 8 to Solaris 9 software, verify the consistency of the storage configuration.
On each node, run the following command to verify the consistency of the storage configuration.
phys-schost# cldevice check |
Do not proceed to Step b until your configuration passes this consistency check. Failure to pass this check might result in errors in device identification and cause data corruption.
The following table lists the possible output from the cldevice check command and the action you must take, if any.
Example Message |
Action |
---|---|
device id for 'phys-schost-1:/dev/rdsk/c1t3d0' does not match physical device's id, device may have been replaced |
Go to Chapter 7, Recovering From an Incomplete Upgrade and perform the appropriate repair procedure. |
device id for 'phys-schost-1:/dev/rdsk/c0t0d0' needs to be updated, run cldevice repair to update |
None. You update this device ID in Step b. |
No output message |
None. |
See the cldevice(1CL) man page for more information.
On each node, migrate the Sun Cluster storage database to Solaris 9 device IDs.
phys-schost# cldevice repair |
On each node, run the following command to verify that storage database migration to Solaris 9 device IDs is successful.
phys-schost# cldevice check |
If the cldevice command displays a message, return to Step a to make further corrections to the storage configuration or the storage database.
If the cldevice command displays no messages, the device-ID migration is successful. When device-ID migration is verified on all cluster nodes, proceed to How to Finish Upgrade to Sun Cluster 3.2 1/09 Software.
The following example shows the commands used to verify upgrade of a two-node cluster to Sun Cluster 3.2 1/09 software. The cluster node names are phys-schost-1 and phys-schost-2.
phys-schost# clnode show-rev -v 3.2 … phys-schost# clnode status === Cluster Nodes === --- Node Status --- Node Name Status --------- ------ phys-schost-1 Online phys-schost-2 Online |
Go to How to Finish Upgrade to Sun Cluster 3.2 1/09 Software.