Führen Sie das Dienstprogramm drvconfig nicht bei hohem E/A-Verkehr auf Platten und Bändern aus, da dies zu Datenüberlauffehlern führen kann.
Datenüberlauffehler können bei hoher Belastung auftreten, wenn Ihr System mit mehreren Platten konfiguriert ist.
Wenn bei der Installation von Solaris Probleme auftreten, setzen Sie die Nummer des Interrupt-Pins der Option ,,Configure Adapter" im AutoSCSI-Dienstprogramm des Herstellers wie folgt ein:
Steckplatz |
Interrupt-Pin |
---|---|
0 |
A |
1 |
B |
2 |
C |
Weitere Informationen finden Sie in den Abschnitten ,,Configuration for Non-Conforming PCI Motherboards" und ,,Handling Motherboard Variations" in der der Platine beiliegenden Dokumentation.
Frühe Versionen von Rev. A, B und C von BT-946C funktionieren unter Solaris vielleicht nicht.
Führen Sie ein Upgrade auf die neueste Firmware 4.25J, BIOS 4.92E und AutoSCSI 1.06E durch, wenn Sie BT946C Rev. B besitzen. Verwenden Sie mindestens ein Upgrade auf BT946C Rev. E.