Solaris Device Driver: |
nfe |
Device Type: |
Network (Ethernet and token ring) |
Adapters: |
Compaq NetFlex-2 DualPort ENET, NetFlex-2 ENET-TR |
Bus Type: |
EISA |
o IRQ Level: |
3, 5, 9, 10, 11 |
Both ports on the Compaq NetFlex-2 DualPort ENET card share the same IRQ.
Although the NetFlex-2 ENET-TR controller can be configured for Ethernet or token ring, Solaris software only supports the Ethernet functionality.
Promiscuous mode is not supported by the firmware for this card.
Set the connector type; use DB-15 or 10BASE-T RJ-45 .
Use the splitter cable (shipped with the DualPort ENET controller) with DB-15 connectors.
If the DualPort ENET card is used to install the Solaris software over a network, connect the RJ-45 connector to the first network port (Port 1).
The default setting (DB-9) on the NetFlex-2 ENET-TR needs to be changed.
Compaq NetFlex-2 ENET-TR card only: Configure this card to use a 10-Mbps data rate, not the default (16 Mbps).