LLP Type
|
Specifies the LLP (Lower
Layer Protocol) type. The valid types are:
-
MLLP (Minimal Lower
Layer Protocol)
-
HLLP (Hybrid Lower
Layer Protocol)
For more information on the available
envelope types, see Lower Layer Protocol in
TCP/IP HL7 adapter Operation.
-
MLLP v2.0 (Minimal
Lower Layer Protocol v2.0)
|
Select MLLP or HLLP or MLLP v2.0.
MLLP is the configured default
value.
|
Start Block
Character
|
Specifies the Start Block Character (the
first envelope marker character in the HL7 envelope) as a decimal
ASCII number.
|
A decimal within the range of 1 to 127. Unless there is a conflict, the value
should be ASCII VT (decimal 11).
The default value is 11.
|
End Data
Character
|
Specifies the End Data Character (the
second to the last envelope marker character in the HL7 envelope)
as a decimal ASCII number. The allowed range is 1 to 127.
|
A decimal within the range of 1 to 127. Unless there is a conflict, the value
should be ASCII FS (decimal 28).
The default value is 28.
|
End Block
Character
|
Specifies the End Block Character (the
last envelope marker character in the HL7 envelope) as a decimal ASCII
number.
|
A decimal within the range of 1 to 127. To be strictly compliant with the HL7
Standard, this parameter MUST be set to a Carriage Return (decimal 13).
The default value is 13.
|
HLLP Checksum
Enabled
|
Specifies whether the HLLP (Hybrid Lower Level Protocol) checksum is
enabled or disabled.
|
Select True or False.
True indicates that the HLLP
Checksum is enabled.
The configured default is True.
|
Max Number
of Retries
|
The maximum number of times the adapter will try sending the
message upon receiving the MLLP v2.0 Negative Commit Acknowledgement
from the peer before giving up.
This parameter is used by HL7 adapter in outbound mode.
|
An integer indicating the number of times the adapter will try
sending the message upon receiving the MLLP v2.0 Negative Commit Acknowledgement
from the peer.
The configured default value is 5.
|