saiptest Hardware Requirements

Before running the SunVTS diagnostics software, make sure you install the device driver and the cards to be tested. Also, you should reboot your system with the boot -r command to reconfigure the system and allow the SunVTS kernel to recognize the new driver.

You must run the saiptest in intervention mode.

The following minimum hardware configuration is required to successfully run the Internal test:

• PCI-based SPARC desktop system with a PCI slot

• Serial Asynchronous Interface card, installed in one of the PCI slots

The following hardware is also required to run other SunVTS Serial Asynchronous Interface tests:

• Serial Asynchronous Interface Patch Panel (Part No. 7600-0027)

• 25-pin serial loopback plugs (Part No. 540-1558)

• RS-232 serial cables (Part No. 530-1685)

• TTY terminal