Appendix A Expert Mode Subcommands

Caution -

The expert mode subcommands should be used only by qualified personnel who are knowledgeable about the systems they are managing.

Expert mode subcommands are listed in the following table.

The command line must contain the luxadm -e (expert mode) option and a subcommand.

luxadm -e subcommand pathname

Table A-1 Expert Mode Subcommands


Subcommand	Description
`bus_getstate`	Gets and displays the state of the specified bus or the bus controlling the specified device.
`bus_quiesce`	Quiesces the specified bus or the bus controlling the specified device.
`bus_reset`	Resets the specified bus or the bus controlling the specified device.
`bus_resetall`	Resets the specified bus or the bus controlling the specified device, and all devices on that bus.
`bus_unquiesce`	Unquiesces the specified bus or the bus controlling the specified device.
`dev_getstate`	Gets and displays the state of the specified device.
`dev_reset`	Resets the specified device.
`forcelip`	Forces the link to reinitialize using the Loop Initialize Primitive (LIP) sequence. This subcommand is supported on the StorEdge A5000 disk array only.
`offline`	Takes the specified device offline
`online`	Puts the specified device online
`rdls`	Reads the link error status block from a specified device. This subcommand also displays the link error status information for the host adapter associated with the specified device, if available. The `rdls` subcommand is supported on the Sun StorEdge A5000 disk array only.