Documentation, Support, and Training
Understanding Switch Specifications
Network Management Connector and Pins
Serial Management Connector and Pins
Understanding InfiniBand Cabling
Floor and Underfloor Delivery of InfiniBand Cables
Overhead Delivery of InfiniBand Cables
Understanding ILOM on the Switch
The design of the switch is such that the power supplies are in a 2+2 redundancy. Because there are four power supplies, this means that two power supplies must be fully functional for the switch to be operational. Typically, line power is provided from two sources, A and B. Configure the switch with A source feeding power supplies 0 and 1, and B source feeding power supplies 2 and 3.
Your switch shipping kit should contain four power cords that are specific to your country or application. The following table describes the power cords available.
|
![]() | Caution - Only install and route power cabling in a matter that complies to federal, state, and local electrical codes. |