| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Solaris Cluster Data Service for Samba Guide |
1. Installing and Configuring HA for Samba
A. Deployment Example: Installing Samba packaged with Solaris 10
Example: Prepare the Cluster for Samba
Example: Configure the Non-Global Zones
Example: Configure Cluster Resources for Samba
Example: Create the Samba smb.conf Configuration File
Example: Enable the Samba Software to Run in the Cluster
Example: Verify the HA for Samba resource group
B. Deployment Example: Installing Samba from http://www.samba.org
Note - This deployment example is designed for a single-node cluster. It is provided simply as a concise guide to help you if you need to refer to an installation and configuration of Samba.
This deployment example is not meant to be a precise guide as there are several alternate ways to install and configure Samba.
If you need to install Samba in any other configuration, refer to the general purpose procedures elsewhere in this manual.
The instructions with this deployment example assumes that you are using the Samba software packaged with Solaris 10 and will configure Samba on a ZFS highly available local file system .
The cluster resource group will be configured to failover between the global zone and two non-global zones on a single node cluster.
The tasks you must perform to install and configure Samba in the global and non-global zones are as follows:
|