| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Solaris Cluster 3.3 With Sun StorEdge 3510 or 3511 FC RAID Array Manual |
| Skip Navigation Links | |
| Exit Print View | |
|
|
Oracle Solaris Cluster 3.3 With Sun StorEdge 3510 or 3511 FC RAID Array Manual |
Storage Array Cabling Configurations
How to Install a Storage Array
Adding a Storage Array to a Running Cluster
How to Perform Initial Configuration Tasks on the Storage Array
How to Connect the Storage Array to FC Switches
How to Connect the Node to the FC Switches or the Storage Array
Configuring Storage Arrays in a Running Cluster
StorEdge 3510 and 3511 FC RAID Array FRUs
How to Remove a Storage Array From a Running Cluster
How to Upgrade Storage Array Firmware
Replacing a Node-to-Switch Component
How to Replace a Node-to-Switch Component in a Cluster That Uses Multipathing
How to Replace a Node-to-Switch Component in a Cluster Without Multipathing
This chapter describes the procedures for installing, configuring, and maintaining the Sun StorEdge 3510 FC RAID array and the Sun StorEdge 3511 FC RAID array with SATA in an Oracle Solaris Cluster environment. This chapter contains the following main topics:
Before you perform any of the tasks in this chapter, read the entire procedure. If you are not reading an online version of this document, have the books listed in the available.
For conceptual information on multihost disks, see the Oracle Solaris Cluster concepts documentation.
|