| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Solaris Cluster 3.3 With Sun StorEdge T3 or T3+ Array Manual SPARC Platform Edition |
| Skip Navigation Links | |
| Exit Print View | |
|
|
Oracle Solaris Cluster 3.3 With Sun StorEdge T3 or T3+ Array Manual SPARC Platform Edition |
1. Installing and Configuring a Sun StorEdge T3 or T3+ Array
Maintaining Sun StorEdge T3 or T3+ Storage Array Components
Sun StorEdge T3 and T3+ Array FRUs
Replacing a Node-to-Switch Component
How to Replace a Node-to-Switch Component in a Cluster That Uses Multipathing
How to Replace a Node-to-Switch Component in a Cluster Without Multipathing
How to Replace a Hub/Switch or Hub/Switch-to-Array Component in a Single-Controller Configuration
How to Replace an FC Switch or Storage Array-to-Switch Component in a Partner-Group Configuration
How to Replace a Storage Array Controller
How to Remove a Storage Array in a Single-Controller Configuration
Upgrading Sun StorEdge T3 or T3+ Storage Arrays
How to Upgrade Storage Array Firmware (No Submirrors)
How to Upgrade Storage Array Firmware When Using Mirroring
How to Upgrade a StorEdge T3 Controller to a StorEdge T3+ Controller
How to Migrate From a Single-Controller Configuration to a Partner-Group Configuration
This chapter contains the procedures about how to maintain Sun StorEdge T3 and Sun StorEdge T3+ arrays in a single-controller (noninterconnected) or partner-group (interconnected) configuration in an Oracle Solaris Cluster Cluster environment.
This book contains the following topics.
For information about how to use a storage array in a storage area network (SAN), see SAN Solutions in an Oracle Solaris Cluster Environment in Oracle Solaris Cluster 3.3 Hardware Administration Manual.
|