How to Backup a File System to Tape (System Administration Guide: Basic Administration)

System Administration Guide: Basic Administration

How to Backup a File System to Tape

The following steps provide the general steps for backing up file systems using the ufsdump command. The examples show specific uses of options and arguments.

Become superuser or assume an equivalent role.

Bring the system to run level S (single-user mode).
# shutdown -g30 -y

(Optional) Check the file system for consistency.
# fsck -m /dev/rdsk/device-name
The fsck -m command checks for the consistency of file systems. For example, power failures can leave files in an inconsistent state. For more information on the fsck command, see Chapter 43, Checking UFS File System Consistency (Tasks).

If you need to back up file systems to a remote tape drive:
1. On the system to which the tape drive is attached (the tape server), add the following entry to its /.rhosts file.
  host root
  The host entry specifies the name of the system on which you will run the ufsdump command to perform the backup.
2. On the tape server, verify that the host added to the /.rhosts file is accessible through the name service.

Identify the device name of the tape drive.

The default tape drive is the /dev/rmt/0 device.

Insert a tape that is not write-protected into the tape drive.

Back up file systems.
# ufsdump options arguments filenames
The following examples show how to use the most common ufsdump options and arguments:
For other ufsdump options and arguments, see Chapter 50, UFS Backup and Restore Commands (Reference).

If prompted, remove the tape and insert the next tape volume.

Label each tape with the volume number, dump level, date, system name, disk slice, and file system.

Bring the system back to run level 3 by pressing Control-D.

Verify that the backup was successful.
# ufsrestore tf device-name

Example—Performing a Full Backup of root (`/`)

The following example shows how to do a full backup of the root (/) file system. The system in this example is brought to single-user mode before the backup. The following ufsdump options are included:

0 specifies that this is a 0 level dump (or a full backup)
u specifies that the /etc/dumpdates file is updated with the date of this backup
c identifies a cartridge tape device
f /dev/rmt/0 identifies the tape device
/ is the file system being backed up

# shutdown -g30 -y
# ufsdump 0ucf /dev/rmt/0 /
  DUMP: Writing 63 Kilobyte records
  DUMP: Date of this level 0 dump: Wed Sep 05 13:27:20 2001
  DUMP: Date of last level 0 dump: the epoch
  DUMP: Dumping /dev/rdsk/c0t1d0s0 (earth:/) to /dev/rmt/0.
  DUMP: Mapping (Pass I) [regular files]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Estimated 57150 blocks (27.91MB).
  DUMP: Dumping (Pass III) [directories]
  DUMP: Dumping (Pass IV) [regular files]
  DUMP: Tape rewinding
  DUMP: 57076 blocks (27.87MB) on 1 volume at 265 KB/sec
  DUMP: DUMP IS DONE
  DUMP: Level 0 dump on Wed Sep 05 13:27:20 2001
  # ufsrestore tf /dev/rmt/0
         2      .
         3      ./lost+found
      3776      ./usr
      7552      ./var
     11328      ./export
     15104      ./export/home
     18880      ./etc
     22656      ./etc/default
     22657      ./etc/default/sys-suspend
     22673      ./etc/default/cron
     22674      ./etc/default/devfsadm
     22675      ./etc/default/dhcpagent
     22676      ./etc/default/fs
     22677      ./etc/default/inetinit
     22678      ./etc/default/kbd
     22679      ./etc/default/mpathd
     22680      ./etc/default/nfslogd
     22681      ./etc/default/passwd
                .
                .
                .
  # (Press Control-d to bring system to run level 3)

Example—Performing an Incremental Backup of root (`/`)

The following example shows how to do an incremental backup of the root (/) file system. The following ufsdump options are included:

9 specifies that this is a 9 level dump (or an incremental backup)
u specifies that the /etc/dumpdates file is updated with the date of this backup
c identifies a cartridge tape device
f /dev/rmt/0 identifies the tape device
/ is the file system being backed up

# ufsdump 9ucf /dev/rmt/0 /
  DUMP: Writing 63 Kilobyte records
  DUMP: Date of this level 9 dump: Fri Jul 13 10:58:12 2001
  DUMP: Date of last level 0 dump: Fri Jul 13 10:46:09 2001
  DUMP: Dumping /dev/rdsk/c0t0d0s0 (starbug:/) to /dev/rmt/0.
  DUMP: Mapping (Pass I) [regular files]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Estimated 200 blocks (100KB).
  DUMP: Dumping (Pass III) [directories]
  DUMP: Dumping (Pass IV) [regular files]
  DUMP: Tape rewinding
  DUMP: 124 blocks (62KB) on 1 volume at 8 KB/sec
  DUMP: DUMP IS DONE
  DUMP: Level 9 dump on Fri Jul 13 10:58:12 2001
# ufsrestore tf /dev/rmt/0
         2      .
         3      ./lost+found
      5696      ./usr
     11392      ./var
     17088      ./export
     22784      ./export/home
     28480      ./opt
      5697      ./etc
     11393      ./etc/default
     11394      ./etc/default/sys-suspend
     11429      ./etc/default/cron
     11430      ./etc/default/devfsadm
     11431      ./etc/default/dhcpagent
     11432      ./etc/default/fs
     11433      ./etc/default/inetinit
     11434      ./etc/default/kbd
     11435      ./etc/default/nfslogd
     11436      ./etc/default/passwd
     11437      ./etc/default/tar
                .
                .
                .

Example—Performing a Full Backup, Individual Home Directory

The following example shows how to do a full backup of the /export/home/kryten directory. The following ufsdump options are included:

0 specifies that this is a 0 level dump (or a full backup)
u specifies that the /etc/dumpdates file is updated with the date of this backup
c identifies a cartridge tape device
f /dev/rmt/0 identifies the tape device
/export/home/kryten is the directory being backed up

# ufsdump 0ucf /dev/rmt/0 /export/home/kryten
  DUMP: Writing 63 Kilobyte records
  DUMP: Date of this level 0 dump: Fri Jul 13 11:30:45 2001
  DUMP: Date of last level 0 dump: the epoch
  DUMP: Dumping /dev/rdsk/c0t3d0s7 (pluto:/export/home) to /dev/rmt/0.
  DUMP: Mapping (Pass I) [regular files]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Estimated 232 blocks (116KB).
  DUMP: Dumping (Pass III) [directories]
  DUMP: Dumping (Pass IV) [regular files]
  DUMP: Tape rewinding
  DUMP: 124 blocks (62KB) on 1 volume at 8 KB/sec
  DUMP: DUMP IS DONE
# ufsrestore tf /dev/rmt/0
         2	   .
      2688	   ./kryten
      5409	   ./kryten/letters
      5410	   ./kryten/letters/letter1
      5411	   ./kryten/letters/letter2
      5412	   ./kryten/letters/letter3
      2689	   ./kryten/.profile
      8096	   ./kryten/memos
        30	   ./kryten/reports
        31	   ./kryten/reports/reportA
        32	   ./kryten/reports/reportB
        33	   ./kryten/reports/reportC
#

Example—Performing a Full Backup to Remote System (Solaris 9 Data to Solaris 9 System)

The following example shows how to do a full backup of a local /export/home file system on a Solaris 9 system (starbug) to a tape device on a remote Solaris 9 system (earth).The following ufsdump options are included:

0 specifies that this is a 0 level dump (or a full backup)
u specifies that the /etc/dumpdates file is updated with the date of this backup
c identifies a cartridge tape device
f earth:/dev/rmt/0 identifies the remote system name and tape device
/export/home is the file system being backed up

# ufsdump 0ucf earth:/dev/rmt/0 /export/home
  DUMP: Writing 63 Kilobyte records
  DUMP: Date of this level 0 dump: Wed Sep 05 14:52:31 2001
  DUMP: Date of last level 0 dump: the epoch
  DUMP: Dumping /dev/rdsk/c0t0d0s7 (starbug:/export/home) to earth:/dev ...
  DUMP: Mapping (Pass I) [regular files]
  DUMP: Mapping (Pass II) [directories]
  DUMP: Estimated 266 blocks (133KB).
  DUMP: Dumping (Pass III) [directories]
  DUMP: Dumping (Pass IV) [regular files]
  DUMP: Tape rewinding
  DUMP: 250 blocks (125KB) on 1 volume at 247 KB/sec
  DUMP: DUMP IS DONE
  DUMP: Level 0 dump on Wed Sep 05 14:52:31 2001
# ufsrestore tf earth:/dev/rmt/0
         2      .
         3      ./lost+found
      7168      ./rimmer
      7169      ./rimmer/.profile
     21504      ./rimmer/scdir
     21505      ./rimmer/scdir/scd557
     21506      ./rimmer/scdir/scd772
     10752      ./lister
     10753      ./lister/.profile
     10754      ./lister/filea
     10755      ./lister/fileb
     10756      ./lister/filec
     14336      ./pmorph
     14337      ./pmorph/.profile
      3584      ./pmorph/bigdir
      3585      ./pmorph/bigdir/bigfile
     17920      ./pmorph/smalldir
     17921      ./pmorph/smalldir/smallfile
 #