Become superuser.
Insert the PCI adapter card into a hot-pluggable slot.
Determine which slot the PCI adapter card is in once it is inserted. Close the latches.
# cfgadm Ap_Id Type Receptacle Occupant Condition pci1:hpc0_slot0 unknown empty unconfigured unknown pci1:hpc0_slot1 unknown empty unconfigured unknown pci1:hpc0_slot2 unknown empty unconfigured unknown pci1:hpc0_slot3 ethernet/hp disconnected unconfigured unknown pci1:hpc0_slot4 unknown empty unconfigured unknown |
Connect the power to the slot.
# cfgadm -c connect pci1:hpc0_slot3 |
Confirm that the slot is connected.
# cfgadm Ap_Id Type Receptacle Occupant Condition pci1:hpc0_slot0 unknown empty unconfigured unknown pci1:hpc0_slot1 unknown empty unconfigured unknown pci1:hpc0_slot2 unknown empty unconfigured unknown pci1:hpc0_slot3 ethernet/hp connected unconfigured unknown pci1:hpc0_slot4 unknown empty unconfigured unknown |
Configure the PCI adapter card.
# cfgadm -c configure pci1:hpc0_slot3 |
Verify the configuration of the PCI adapter card in the slot.
# cfgadm Ap_Id Type Receptacle Occupant Condition pci1:hpc0_slot0 unknown empty unconfigured unknown pci1:hpc0_slot1 unknown empty unconfigured unknown pci1:hpc0_slot2 unknown empty unconfigured unknown pci1:hpc0_slot3 ethernet/hp connected configured unknown pci1:hpc0_slot4 unknown empty unconfigured unknown |
Configure any supporting software if this device is a new device.
For example, if this device is an Ethernet card, use the ifconfig command to set up the interface.