SunVTS 7.0 Patch Set 3 Release Notes |
The SunVTS 7.0 Patch Set 3 software is designed for the Solaris 10 10/08 or later operating system (OS).
Note - All tests released in SunVTS 7.0 are documented in the SunVTS 7.0 Software User’s Guide. |
For the latest version of this document (820-5771) and other SunVTS documentation, go to: http://docs.sun.com/app/docs/prod/test.validate
SunVTS 7.0 Patch Set 3 supports all Sun manufactured x86/x64 systems. Non-Sun systems are not supported.
Note - If you run SunVTS on unsupported platforms, a warning message will be displayed stating that the platform is not supported. Nevertheless, testing would be allowed to move forward. |
You must install the x86 version of the SunVTS packages to perform SunVTS on x86 platforms. The software packages use the same names as in the SPARC® environment. The SunVTS packages delivered separately for both x86 and SPARC Solaris platforms are as follows:
The SunVTS components available for x86 Solaris platforms are as follows.
Starting with SunVTS 7.0 Patch Set 3, there are two bootable versions of SunVTS on x86 available for download. One contains SunVTS with all user interfaces, including the Browser User Interface (BUI) and the other (which does not include the BUI) instead relies on vtstty for user interface.
Starting with SunVTS 7.0 Patch Set 3, the default value for Test Time, Test Pass and Scheduling Policy for all three test modes has been changed. Test options are selected from the Test Options Screen of the SunVTS 7.0 browser user interface (BUI) (see the SunVTS 7.0 Software User’s Guide, Chapter 3, “Using the SunVTS Browser User Interface”). The following default values are:
1. Select options for each Test and modify the Scheduling Policy Test Time option.
(See Table 3-14, Test Options Screen, Chapter 3, “Using the SunVTS Browser User Interface” of the SunVTS 7.0 Software User’s Guide).
2. Select the time in minutes that you wish to be the default.
Scheduling Test Time (min) test time field
Policy
In the test time field, specify the number of desired default in minutes.
3. Once the options for all Tests are modified, start the tests.
Use pkgadd for installation and pkgrm to uninstall.
When a user runs Bootable CD on Sun Fire x4150/x4250 and Sun Fire x4450 systems, Network Test appears disabled by default. If the user enables the Network Test and starts testing, they might notice a test failure since the e1000g driver does not provide internal loopback mode support.
When starting SunVTS 7.0ps3, the user may see the following warnings:
These warnings can be safely ignored, SunVTS will start as expected in spite of these warnings.
Workaround: Do not run Network Test in SL-1 or SL-2.
Workaround: Do not run Network Test in SL-1 or SL-2.
You can request Sun support and provide feedback to Sun at the following email address:
Copyright © 2008 Sun Microsystems, Inc. All Rights Reserved.