A P P E N D I X C |
Installing the Solaris OS and the RAID 5 Expansion Module Driver |
If you chose to create a bootable array as part of your installation (see Appendix B), you can install the Solaris operating system (OS) and the REM driver on that bootable array.
This appendix explains how to install the Solaris OS onto a bootable array (logical drive) and then install the REM driver on the array (logical drive).
Note - This appendix assumes you are experienced with Solaris network installs. |
Before you begin, prepare to install the Solaris operating system.
|
Complete the procedures in Appendix B.
Note - For up-to-date Sun StorageTek SAS RAID HBA support, go to http://support.intel.com/support/go/sunraid.htm. |
This section contains the following subsection:
|
1. Obtain the Solaris 10 5/08 OS and perform a normal network installation, as described in the Solaris 10 Installation Guide: Network-Based Installations, until you encounter the prompt, Reboot After Installation?.
Note - Do NOT select Auto Reboot at this point in the network installation process. |
2. Specify that you want to perform a Manual Reboot.
Specifying a manual reboot provides you with the opportunity to install the HBA driver after all other Solaris software is in place. Without this driver, subsequent reboots will fail.
3. Use the df command to verify the following:
/a is the standard Solaris mount point for the disk on which the OS is being installed.
4. If the product install directory and the logical drive are not mounted, manually mount them.
Note - With this example, you must substitute the correct host names, directory paths, and device paths in your environment. |
# mount /dev/dsk/c2t0d0s0 /a (for the logical drive) # mount install_host:install_dir_path /cdrom (for the install server products) |
5. Apply the HBA driver package, SUNWaac.
6. Apply any patches that are specifically required for the system.
The system will now be able to see, and boot from, the logical drive on which you installed the Solaris OS.
You can optionally install and use the Sun StorageTek RAID Manager GUI to create arrays on the disk enclosure. See the Sun StorageTek RAID Manager User’s Guide at: http://docs.sun.com/app/docs/prod/stortek.raid.hba
For more information, refer to the following documents at: http://docs.sun.com/app/docs/coll/dsk-cntrl
For Sun RAID controller drivers, firmware, and utilities including Sun StorageTek RAID Manager for SPARC (8/4/2008) Version 5.50, go to: http://support.intel.com/support/motherboards/server/sunraid/
Copyright © 2010, Oracle and/or its affiliates. All rights reserved.