Sun Blade T6340 Server Module
Installation and Administration Guide
820-3900-12
Contents |
1. Before You Begin the Installation
Managing the Server Module With ILOM
ILOM on the CMM and Server Module SP
Establishing Communication With ILOM
Attaching a Serial Console to the Chassis Management Module
Attaching a Serial Console to the Server Module
2. Installation and Configuration
Installing the Server Module into the Chassis
Connecting and Configuring the Server Module
Connecting to the Server Module
Connecting Through the Chassis CMM Ethernet Port
Connecting to the Server Module SP Through the Chassis CMM Serial Connector
Connecting to the Server Module SP Using a Dongle Cable
To Connect a Storage Device to the Dongle Cable
Configuring and Viewing the IP Address for a Server Module SP
Configuring and Viewing the IP Address for a Server Module SP Through the CMM
To View or Configure the IP Address for the Server Module SP When Assigned by DHCP -- Through the CMM
To View or Configure the IP Address for the Server Module SP Using Static IP Addresses -- Through the CMM
Configuring and Viewing the IP Address for a Server Module SP Through the UCP
To View or Configure the IP Address for the Server Module SP When Assigned by DHCP -- Through the UCP
To View or Configure the IP Address for the Server Module SP Using Static IP Addresses -- Through the UCP and Dongle Cable
Connecting a Remote Console or Remote KVMS
Switching Between the ILOM Prompt and the System Console
To Switch Between the ILOM Prompt and the System Console
Connecting to the Server Module With a Local Graphics Monitor or Local KVMS
To Access the System Console Through a Local Graphics Monitor
To Power on the Server Module Manually
Installing the Solaris Operating System on a Hard Drive
JumpStart Server Configuration
Integrated Stripe Volumes (RAID 0)
Integrated Mirror Volumes (RAID 1)
Physical Disk Slot Numbers, Physical Device Names, and Logical Device Names for Non-RAID Disks
To Create a Hardware Mirrored Volume
To Create a Hardware Mirrored Volume of the Default Boot Device
To Create a Hardware Striped Volume
To Configure and Label a Hardware RAID Volume for Use in the Solaris Operating System
To Delete a Hardware RAID Volume
To Perform a Mirrored Disk Hot-Plug Operation
To Perform a Nonmirrored Disk Hot-Plug Operation
Openboot ok Prompt Not Available After Solaris OS Has Started
Graceful Reset of the Control Domain With ILOM reset Command
To Shut Down the Server Module Using the Break Key or the Equivalent Pair of ILOM Commands
Procedures for Obtaining the ok Prompt
OpenBoot Configuration Variables on the SP
A. Device Tree for the Sun Blade T6340 Server Module
Copyright © 2010, Oracle and/or its affiliates. All rights reserved.