A P P E N D I X B |
![]() |
The anti-tilt bar or anti-tilt legs must be extended or the equipment rack will topple when the server is installed on the extended slide rails.
1. Pull the end of the anti-tilt bar out to its fully extended position.
2. Rotate the foot 90 degrees and adjust the height of the foot so that it rests on the floor.
FIGURE B-1 Extending the Anti-Tilt Bar on the Sun Rack 1000
1. Pull the unlocking ring (FIGURE B-2).
2. Pull the bottom foot of the anti-tilt leg away from the cabinet until it extends fully (Number 2 in FIGURE B-2).
The leg support will lock in place.
FIGURE B-2 Extending the Anti-Tilt Legs
3. Rotate the leg’s rubber foot clockwise until it touches the floor (Number 3 in FIGURE B-2).
The foot must touch the floor to stabilize the cabinet securely.
4. Extend the other anti-tilt leg.
Copyright © 2009, 2011, Oracle and/or its affiliates. All rights reserved. FUJITSU LIMITED provided technical input and review on portions of this material.