C H A P T E R 3 |
Information About Software |
This chapter describes specific software and firmware issues and workarounds. It includes the following sections:
This section lists XCP issues known to exist in the XCP 1092 release. If you are using XCP 1090 or 1091 firmware, refer to this section in the Sun SPARC Enterprise M3000 Server Product Notes for that version of the firmware.
TABLE 3-1 lists XCP issues and possible workarounds.
This section contains information about Solaris OS issues. The following tables list issues you might encounter, depending in part on which Solaris OS release you are using.
TABLE 3-2 lists Solaris OS issues that you might encounter in any Solaris release. If your domains are not running the latest Solaris release, also take notice of CRs fixed in releases later than yours, as noted in the tables that follow.
TABLE 3-4 lists issues that have been fixed in Solaris 10 10/09 OS. You might encounter them in earlier releases.
TABLE 3-4 lists issues that have been fixed in Solaris 10 5/09 OS. You might encounter them in earlier releases.
TABLE 3-5 lists issues that have been fixed in Solaris 10 10/08 OS. You might encounter themin earlier releases..
This section contains late-breaking information that became known after the listed document was published or that was very recently added.
Note - Online man pages are updated more frequently than the SPARC Enterprise M3000/M4000/M5000/ M8000/M9000 Servers XSCF Reference Manual. |
The following changes are not included in the XCP 1090 edition of this document dated August 2009.
The following changes were added to or not included in the August 2009 edition of this document.
Not yet added. See Active Directory and LDAP/SSL of these Product Notes. |
|
Added in the 1090 update of this document: In the following cases, inaccurate power consumption values might be shown in the MIB, in the showenvironment power command output, and on the XSCF Web:
To ensure the values are accurate, wait one minute, then check the values again. |
|
Not yet changed in Chapter 8.1.10:
2. If the replacement unit and the replaced unit have different versions, a message is displayed. In this case, the firmware is not updated automatically. The operator must match the number of the firmware versions. 3. When you update, follow the procedure in "Updating XCP From External Media" or "Updating XCP from the Network." After updating, confirm the version. |
Copyright © 2010, Oracle and/or its affiliates. All rights reserved.