Sun Java System Identity Pack 2005Q4M3 Installation |
11
Install the Sun Identity Manager Gateway
If you plan to set up Windows Active Directory, Novell NetWare, Novell GroupWise, Exchange 5.5, Remedy, or RSA ACE/Server resources, you should install the Sun Identity Manager Gateway.
PrerequisitesIf you are using Domino, there are additional steps to perform for Domino gateway configuration. See the chapter titled Resources Reference in Identity Manager Technical Reference.
The Sun Identity Manager Gateway may be installed on Windows 2000 SP3 or above and Windows 2003 platforms.
Installation
To install the gateway on a Windows machine:
- Select the Windows machine on which to install the gateway. It must be a member of the domain in which the accounts and other objects will be managed (the managed domain) or a member of a domain that is trusted by the managed domain. The gateway does not need to run on a domain controller.
Tip For better performance, the gateway should be located near (from a network connectivity perspective) the domain controllers of the managed domain.
- If you are selecting a system that is not the Identity Manager server, then:
- From the directory where the gateway files are installed, run the following command to install the gateway as a service:
gateway –i- Run the following command to start the gateway service:
gateway -s
Notes
Failure Messages
Two common messages and their likely causes when working with the gateway are as follows:
- 'Overlapped I/O operation is in progress'
The most common cause of this message is that you have asked for the service to be installed or removed before a prior installation or removal has fully completed. Check the state of the service.
- 'Input/output error'
The most common cause of this is that you do not have rights to work with this service.
What’s Next?
To begin using Identity Manager, follow the steps in Chapter 12, Getting Started.