1. Hold the cover at an angle of approximately 30 degrees in relation to the
system unit chassis, and gently guide the plastic tabs on the cover into the
tab slots on the front of the chassis. Continue to hold the cover with your
hands.
Caution - Holding the cover at angles greater than 30 degrees can prevent
insertion of the tabs into the tab slots. Once the tabs are in the slots, raising the
cover to angles greater than 30 degrees can break the tabs.
2. Slowly lower the cover onto the chassis, and be sure the protector loop
clears the diskette drive (if equipped) and seats into the protector loop
slot on the bottom of the chassis.
3. Push down on the top cover's right and left sides.
4. Insert and tighten the two screws which hold the top cover to the back
panel.
Use a Phillips screwdriver to tighten the two screws.
See the following sections in the SPARCstation 2 Installation Guide about
powering up your system:
-
"Powering Up the System," Chapter 3, for single systems
-
"Powering Up the System," Chapter 4, for networked systems
See the following document about powering up external drive units:
- Desktop Storage Pack Installation Guide
Warning - Do not power up the system unit without replacing the cover and
securing it. Failure to take this precaution may result in personal injury and
system damage.
