To install an internal drive, you will need the following tools, software release,
and materials:
-
Needlenose pliers (for disk drive jumper settings)
-
Antistatic mat (if available) or the antistatic bag the disk drive
was shipped in
-
SCSI regulated terminator
-
External SCSI cable (for SBus Expansion Subsystem only)
-
SunOS 4.1.3 or a higher version
Determine which version of the operating system you are running. For
example, for either the Solaris 1.x (SunOS 4.x) or Solaris 2.x systems, enter:
uname -rs
Prior versions of these operating systems do not support this hard disk drive.
If you are replacing either a system or a data disk, you need to back up your
system. Refer to the system administration manual that was shipped with your
system unit or operating system.
Before turning off the system power, you must halt the operating system:
1. Go to the handbook appropriate for your operating system.
2. See the section about shutting down the system, then return to this
manual after you perform this procedure.
Caution -
Halt the system in an orderly manner. When the operating system or
any other stand-alone program has already booted, do not use the STOP-A
(L1-A) keys to halt the system. Abruptly aborting execution of the program
may cause damage to data files.
Refer to the appropriate chapter in this manual to install or replace the 1.05
Gbyte disk drive in your particular system:
-
For SPARCstation 2, see Chapter 2.
-
For SPARCstation 10, see Chapter 3.
-
For the SBus Expansion Subsystem, see Chapter 4.
-
For SPARCstation IPC, see Chapter 5.
-
For SPARCstation IPX, see Chapter 6.
-
For SPARCclassic and SPARCstation LX systems, see Chapter 7.
