Using the ndd Utility in Interactive Mode

1. To modify a parameter value in interactive mode, specify ndd /dev/qfe, as shown below.

   The ndd utility then prompts you for the name of the parameter:

   ---

   # ndd /dev/qfe
   name to get/set? (Enter the parameter name or ? to view all parameters)

   ---

After entering the parameter name, the ndd utility prompts you for the parameter value (see Table C-1 through Table C-8).

1. To list all the parameters supported by the qfe driver, type ndd /dev/qfe \?.

   (See Table C-1 through Table C-8 for parameter descriptions.)

   ---

   # ndd /dev/qfe \? 
   ?                             (read only)
   transceiver_inuse             (read only)
   link_status                   (read only)
   link_speed                    (read only)
   link_mode                     (read only)
   ipg1                          (read and write)
   ipg2                          (read and write)
   use_int_xcvr                  (read and write)
   pace_size                     (read and write)
   adv_autoneg_cap               (read and write)
   adv_100fdx_cap                (read and write)
   adv_100hdx_cap                (read and write)
   adv_10fdx_cap                 (read and write)
   adv_10hdx_cap                 (read and write)
   autoneg_cap                   (read only)
   100fdx_cap                    (read only)
   100hdx_cap                    (read only)
   10fdx_cap                     (read only)
   10hdx_cap                     (read only)
   lp_autoneg_cap                (read only)
   lp_100fdx_cap                 (read only)
   lp_100hdx_cap                 (read only)
   lp_10fdx_cap                  (read only)
   lp_10hdx_cap                  (read only)
   instance                      (read and write)
   lance_mode                    (read and write)
   ipg0                          (read and write)
   # 

   ---