Save and Restore Procedures

To Eject a Diskette

1. Choose System Administration: Save and Restore Configuration>Eject diskette.

   The Eject Diskette Administration page is displayed, indicating that the diskette has been ejected.

To Save the System Configuration

1. If saving the configuration to diskette, insert the diskette into the drive; otherwise proceed to Step 2.

   Make sure the diskette is not write protected.

2. Choose System Administration: Save and Restore Configuration.

   The Save And Restore Configuration Administration page is displayed.

3. Choose either Save configuration to diskette or Save configuration to file system; then confirm the operation.

To Restore the System Configuration

1. If restoring the configuration from a diskette, insert a diskette into the drive; otherwise proceed to Step 2.

2. Choose System Administration: Save and Restore Configuration.

   The Save And Restore Configuration Administration page is displayed.

3. Choose either Restore configuration from diskette or Restore configuration from file system.

   The Restore Configuration Administration page is displayed.

4. Make the entries in the form using Table 11-4.

   Table 11-4 Restoring System Configuration

   Restore entire configuration	Restores all configurations from the diskette/disk.
   Restore selected configurations	Restores only the selected configurations from the diskette/disk. If this option is chosen, at least one configuration must also be chosen; if any configuration is chosen, this option must also be chosen.

   ---

   Note -

   It is strongly recommended that you restore only your entire configuration.

   ---