monitor_rpcbind Error Messages

The following error messages potentially produced by monitor_rpcbind were omitted from the Sun Cluster 2.2 Error Messages Manual.

SUNWcluster.monitor_rpcbind.1001: Invalid daemon:

This message indicates that the daemon name is set incorrectly. To remedy this, contact your Sun representative.

SUNWcluster.monitor_rpcbind.3001: Failed to restart rpcbind -w. Aborting this node.

This message indicates that rpcbind is not running on this node, and the system attempted unsuccessfully to restart it. The system will be aborted automatically.

SUNWcluster.monitor_rpcbind.4502: rpcbind is not running -- manual reboot may be needed

This message indicates that rpcbind is not running on this node and could not be restarted automatically by the system. The system will be aborted automatically.

SUNWcluster.monitor_rpcbind.5001: rpcbind is not running but warm restart seems to be possible. Will attempt to restart.

This message indicates that rpcbind is not running on this node and an attempt will be made by the system to restart it. This is an informational message only; no user action is necessary.

SUNWcluster.monitor_rpcbind.5002: rpcinfo failed - no rpcbind.

This message indicates that the test for an active rpcbind failed, for whatever reason is specified in the message. This is an informational message only; no user action is necessary.

SUNWcluster.monitor_rpcbind.5003: rpcbind in process list but has not responded.

This message indicates that although rpcbind appears in the process table for the system, it has failed to respond to the fault monitor in the required time. The fault probe will be retried automatically. This is an informational message only; no user action is required.

SUNWcluster.monitor_rpcbind.5010: rpcbind is not running on this node and cannot be restarted. This node will be aborted.

This message indicates that rpcbind is not running on this node and an unsuccessful attempt was made by the system to restart it. As a result this node will abort automatically. No user action is required.

SUNWcluster.monitor_rpcbind.5011: rpcbind is not running on this node and cannot be restarted. Selected action is to continue operation.

This message indicates that rpcbind is not running on this node and the system was unable to restart it. Because the fault monitor has been told not to abort the node, operation will continue. However, the Sun Cluster framework will not be able to reconfigure without operator intervention. Reboot the node manually to ensure correct operation.

SUNWcluster.monitor_rpcbind.6000: Restarted the daemon rpcbind, pid= <pid> 

This message indicates that rpcbind was not running on this node and was successfully restarted by Sun Cluster. No user action is required.