/opt/SUNWvts/bin/atmtest standard_arguments,-o dev=device,tpkts=n,nv=n,ml=n,bw=n,opkts=n,warn,ld,sd,sl,nc,ns,vcf=n
Table 4-3 atmtest Command-Line Syntax
Argument |
Description |
---|---|
dev=device |
Specifies the device name to be tested, such as ba0 or sa0. |
tpkts=n |
Specifies the number of packets to loopback, -1 for continuous [1...2147483647, -1]. |
nv=num_vc |
Specifies the number of simultaneous virtual circuits to be tested. |
ml=max_len |
Specifies the maximum length of the random packet. |
bw=bandwidth |
Specifies the bandwidth in MBits/s of a virtual circuit. |
opkts=n |
Specifies the number of packets for each virtual circuit that can be transmitted without receiving a corresponding packet. |
warn |
When enabled, prints warning messages. |
ld |
The internal loopback mode is selected. |
sd |
Changes the payload data to static instead of random. |
sl |
Changes all packets to their maximum length. |
nc |
Instructs the test not to check the receive payload (improves throughput). |
ns |
Instructs the test not to exit on a packet reception failure. |
vcf=n |
Specifies the first virtual circuit number used. |
64-bit tests are located in the sparcv9 subdirectory: /opt/SUNWvts/bin/sparcv9/testname. If the test is not present in this directory, then it may only be available as a 32-bit test. For more information refer to "32-Bit and 64-Bit Tests".