Sun N1 Grid Engine 6.1 Administration Guide

Configuring the Checkpointing Parameters

To configure the checkpointing parameters, click the Checkpointing tab. The Checkpointing tab is shown in the following figure.

Dialog box titled Modify <queue-name>. Shows
the Checkpointing tab with parameters you can set. Shows Ok, Cancel,
Refresh, and Help buttons.

You can specify the following parameters:

To reference a checkpointing environment from the queue, select the name of a checkpointing environment from the Available list, and then click the right arrow to add it to the Referenced list.

To remove a checkpointing environment from the Referenced list, select it, and then click the left arrow.

To add or modify checkpointing environments, click the button below the red arrows to open the Checkpointing Configuration dialog box. For more information, see Configuring Checkpointing Environments With QMON.

See the queue_conf(5) man page for detailed information about these parameters.