About This Documentation (PDF and HTML)
Oracle Hardware CLI Tools Overview
Installing Components Using the Oracle Hardware Management Pack Installer
Installing Hardware Management Pack Components Using Installer
CLI Tools Command Syntax and Conventions
CLI Tools Device-Naming Convention
Configuring the Device Boot Order
Commands That Produce Unrelated, Innocuous, Extra Output
fwupdate Command-Line Interface
Automatic Mode update Subcommand
remove spare Subcommand and Options
Sun IPMI System Management Driver 2.1
After firmware for a device has been updated, the device might need to be reset. This requirement is different with each device; therefore, the reset functionality might be part of the update procedure or a separate function. To determine if your device requires a reset after a firmware upgrade, consult the release notes of your firmware.
The supported targets for the fwupdate reset command are:
all
disk
expander
bridge
controller
Options for the update subcommand are shown in the following table.
|
The following is a fwupdate reset subcommand example. This example resets the disk mapped to c2d2.
# fwupdate reset disk -n c2d2
See also: