JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Blade X6275 M2 Server Module Service Manual
Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Service Manual Overview

Using This Documentation

Product Information Web Site

Related Books

About This Documentation (PDF and HTML)

Documentation Comments

Contributors

Change History

Server Module and Components Overview

Product Description

Product Features

About the Sun Blade 6000 Modular System Chassis

Illustrated Parts Breakdown

Front Panel LEDs and Features

Power and Reset

Power Modes

Power Button and Power OK LED

Powering On and Off the Server Module

Preparation Procedures for Service and Operation

Preparing the Server for Service

Preparing the Server for Operation

Component Removal and Installation Procedures

Replacing the System Battery

Removing and Installing DIMMs

Removing and Installing Flash Modules

Removing and Installing the Energy Storage Modules

How to Remove the Energy Storage Modules

How to Install the Energy Storage Modules

Removing and Installing the Service Processor Board

Removing and Installing USB Flash Drives

Removing and Installing a CPU and Heatsink Assembly

How to Replace the Motherboard Assembly

Diagnostic and Maintenance Information and Procedures

Diagnosing Server Module Hardware Faults

BIOS Power-On Self-Test (POST) Codes

Server Module Maintenance Procedures and Information

Specifications

Dimensions

Environmental Specifications

USB Flash Drive Specifications

Index

How to Install the Energy Storage Modules

Note - This component is a customer-replaceable unit (FRU).

Note - The Sun Blade X6275 M2 Server module is a dual-node server. If necessary, use this procedure for both nodes.

Before You Begin

  1. Prepare the server module for service. See Preparing the Server for Service.
  2. Position the rear ESM in the empty holder with the cable facing up and toward the rear of the server.
    image:An illustration showing how to install the energy storage modules.
  3. Slide the ESM into the holder and guide the cable into the cable slot on the back side of the holder.
  4. Position the front ESM in the empty holder with the cable facing up and toward the front of the server.
  5. Slide the ESM into the holder and guide the cable into the cable slot on the front of the holder.
  6. Connect the two cables to the connectors on the motherboard.
  7. Buckle the retaining strap by guiding the strap through the buckle and pulling it until tight.
  8. Install the SP board. See How to Install the Service Processor Board.
  9. Prepare the server module for operation. See How to Prepare the Server Module for Operation.

See Also

Removing and Installing Flash Modules

Copyright © 2010, 2013, Oracle and/or its affiliates. All rights reserved. Legal Notices
Previous Next