| Skip Navigation Links | |
| Exit Print View | |
|
Sun Blade X6275 M2 Server Module Installation Guide |
About This Documentation (PDF and HTML)
Overview of the Sun Blade X6275 M2 Server Module
Server Module Front Panel and Indicators
Installing and Powering On the Server Module
About Your Server Module Shipment
Finding the Serial Number and Accessing Warranty Support Information
How to Install Your Server Module
How to Apply Full Power to a Server Module Node
How to Power Off a Server Module Node
Troubleshooting Server Power States
Configuring an ILOM IP Address
The Sun Blade X6275 M2 server module supports one Sun Flash Module (FMod) per node. The FMod is seen by the node as a local SATA disk drive and is controlled by the built-in ICH10 disk controller. It can be used to install and boot a supported operating system.
For information about how to install flash modules, refer to the Sun Blade X6275 M2 Server Module Service Manual.
 | Caution - Do not remove or insert a flash module until the green FMod power LED on the motherboard goes out. This LED (next to the FMod slots) indicates that there is power to the FMod from the energy storage module (ESM). Damage to the flash module can occur if the FMod is removed while the green FMod power LED is lit. It can take 20 seconds or more for the ESM to discharge and the LED to go out. |
See Also
|