C H A P T E R 1 |
Planning for the Installation |
This chapter describes the requirements for preparing the customer site for installation of Sun Storage 2500-M2 Arrays. It contains the following sections:
The customer is obliged to inform Oracle Corporation of any and all ordinances and regulations that might affect the installation. The customer is responsible for meeting all government codes and regulations concerning facilities. The customer is also required to do the following:
Install Sun Storage 2500-M2 Arrays in accordance with the local safety codes and regulations at the facility site. Make sure that you read the safety precautions in the Sun Storage 2500-M2 Arrays Regulatory and Safety Compliance Manual.
The following sections contain additional safety information for the local facility:
Note - Do not make mechanical or electrical modifications to the equipment. Oracle Corp. is not responsible for regulatory compliance of a modified product. |
Caution - A fully populated cabinet can weigh in excess of 1500 pounds (682 kg). Ensure that all surfaces this system will move over can withstand this load. |
The cabinet is equipped with wheels so you can move it. Use enough personnel when moving the cabinet, especially on sloped loading docks and ramps, to gain access to a raised computer room floor. Move the cabinet slowly and deliberately, and make sure that the floor is free from foreign objects and cables that the cabinet could roll over.
Caution - To avoid injury, wear protective footwear when moving a system. |
To minimize personnel injury in the event of a seismic occurrence, you must securely fasten the cabinet to a rigid structure extending from the floor to the ceiling, or from the walls, of the room in which the cabinet is located.
Install the cabinet on a level surface. At each corner, on the base of the cabinet, are adjustable nonskid pads. Extend these pads when the cabinet is installed to prevent the cabinet from rolling. Do not use these pads to level the cabinet.
Allow enough room surrounding the cabinet for access to the cabinet and arrays for maintenance.
Air cools the system cabinets from front to back. Air enters at the front, circulates, and is expelled at the back of the cabinet. The front and back door clearances provide sufficient space for cooling. See Chapter 2 for specific clearance specifications.
Copyright © 2011, Oracle and/or its affiliates. All rights reserved.