Sun Blade X3-2B Model Name Change
Getting the Latest Firmware and Software
About the Chassis Monitoring Module (CMM)
Replaceable Server Module Components
Preparing the Sun Blade X3-2B for Service
Obtaining the Server Module Serial Number
Powering Off the Server Module
Performing ESD and Antistatic Prevention Measures
Remove the Server Module from the Sun Blade Chassis
Remove the Server Module Top Cover
Removing or Inserting Filler Panels
Servicing Sun Blade X3-2B Components
Servicing a Storage Drive (CRU)
Replace the System Battery (CRU)
Servicing USB Flash Drives (CRU)
Servicing a Fabric Expansion Module (CRU)
Servicing a RAID Expansion Module (CRU)
Servicing a Processor and Heat Sink Assembly (FRU)
Servicing the Motherboard Assembly (FRU)
Returning Sun Blade X3-2B to Operation
Install the Server Module Top Cover
Install the Sun Blade X3-2B in the Chassis
Troubleshooting the Sun Blade X3-2B
Diagnosing Server Module Hardware Faults
Troubleshooting Using LED Status Indicators
Using the DIMM and Processor Test Circuit
Troubleshooting Server Module Power States
Firmware and Software Troubleshooting
BIOS Power-On Self-Test (POST) Checkpoints
About POST Code Checkpoint Memory Testing
POST Code Checkpoint Reference
Getting Server Firmware and Software
Firmware and Software Access Options
Available Software Release Packages
The topics included in this section show the location of the front panel LEDs and buttons and describe their functions.
This illustration shows the location of the front panel LEDs and buttons.
The descriptions and functions are described below.
Functionality:
Combination white LED and button.
The Locate LED button is used to activate the Locate LED to identify a server module within a chassis.
The Locate LED button is also used for some Oracle ILOM procedures.
Press the Locate LED button to activate the Locate LED. You can also remotely activate the Locate LED from Oracle ILOM.
Functionality:
Blue LED.
Indicates when it is safe to remove the server module from the chassis.
Off: Normal operation. Do not remove the server module.
On solid: The server module is ready to remove. See Remove the Server Module from the Sun Blade Chassis.
Functionality:
Amber LED.
Service Action Required LED indicates a server module fault.
Off: Normal operation.
On solid: The server module has a fault. See Troubleshooting the Sun Blade X3-2B.
Functionality:
Green LED.
Power button is used to toggle the server between standby power and full power mode.
Operation of the Power button requires the use of a stylus.
The Power/OK LED indicates the status of the server power.
LED states:
Service processor is starting: Fast blink
Host is booting: Slow blink at 1 Hz.
Standby power mode: Blink 0.2 seconds on, 2.8 seconds off
Full power mode: On solid (does not blink)
Press to power the server module on or off. See Powering Off the Server Module or Powering On the Server Module.
Functionality:
The NMI (non-maskable interrupt) button is for service use only. Do not press.