Verify Installation (CMM ILOM CLI)

The NEM is automatically detected when the chassis is powered on.

You can connect to the ILOM CLI by either of two methods:

• Connect a terminal or PC running a terminal emulator directly to the CMM serial port on your chassis.

  or

• Connect to the chassis Ethernet network management port using a secure shell (ssh).

Instructions for setting up and using ILOM are in .

1. Log in to the CMM ILOM.
2. Type the following command:

   -> show /CH/NEMx

   where x is 0 or 1, depending on the slot the NEM is installed in.

   The NEM and the NEM FRU information is displayed in the CLI.

    Targets:
           MB
           SAS
           SP
           PRSNT
           STATE
           ERR
           OK
           SERVICE
           OK2RM
           LOCATE
       Properties:
           type = Network Express Module
    ipmi_name = NEM0
           fru_name = SUN BLADE 6000 VIRTUALIZED MULTI-FABRIC 40GE PCI-EX NEM
           fru_version = SAS 5.3.8.1
           fru_part_number = 541--4391-01
           fru_serial_number = 0328MSL-1113L20028
           fru_extra_1 = SAS 5.3.8.1
           fault_state = Ok
           load_uri = (none)
           clear_fault_action = (none)
           prepare_to_remove_status = NotReady
           prepare_to_remove_action = (none)
           return_to_service_action = (none)
       Commands:
           cd
           load
           reset
           set
           show

3. Verify that the NEM has joined the SAS fabric by typing:

   ->  show /STORAGE/sas_zoning

   /STORAGE/sas_zoning
       Targets:
           BL0
           BL2
           BL3
           BL5
           BL7
           BL8
           BL9
           NEM0
           NEM1
       Properties:
           zone_management_state = enabled
           reset_password_action = (Cannot show property)
           reset_access_action = (Cannot show property)
       Commands:
           cd
           set
           show

4. If the NEM does not appear in ILOM, verify that the NEM is properly seated in the chassis, then verify that you have the newest CMM ILOM firmware.

   For more information about using CMM ILOM, see the ILOM documentation, at:

   http://docs.oracle.com/cd/E19860-01/

Related Information

• Verify Installation (CMM ILOM Web)

• Remove a NEM

• Replace a NEM

• Installing and Removing SFP+ Optical Transceiver Modules

• SFP+ Connector Cabling Options

• Understanding the NEM