Use this section level rule to set the section overlay/page segment X and Y coordinates. Using this rule, you specify where the page segment will be placed on the printed page.
You can also use the SetOrigin and SetOriginM rules. SetOrigin works just like this rule except you enter X and Y coordinates in FAP units, instead of inches. There are 2400 FAP units per inch.
SetOriginM works just like this rule except you enter X and Y coordinates in millimeters. There are approximately 25.4 millimeters per inch.
SetOriginI (Fixed,X,Y,Form,Store(),ImageName)
|
Parameter |
Description |
|
FIXED |
(Optional) Anchors the section at the specified X and Y coordinates. This must be the first parameter listed. See Fixing a section’s position for more information. |
|
X |
Sets the X coordinate for a section. This determines the section’s horizontal position. |
|
Y |
Sets the Y coordinate for a section. This determines the section’s vertical position. |
|
Form |
(Optional) The form name on which the section exists. This parameter lets you define more than one SetOrigin rule for a section and specify which one applies based on the name of the form. |
|
Store( ) |
(Optional) This parameter lets you store the current section coordinates in prefix-name variables for later use. The syntax is: Store(prefix-name variable) For Windows, the coordinates are stored in: prefix-name.left, prefix-name.right, prefix-name.top, and prefix-name.bottom The stored coordinates can be referenced from any page in the form set. |
Specify the X and Y coordinates using a combination of the following parameter prefixes plus the addition or subtraction of measurements you specify in inches. Here are the prefixes you can use:
|
Prefix |
Description |
|
Abs |
Absolute page position based on inches. (supports overflow) |
|
Rel |
Relative to the last section’s top left coordinate. (supports overflow) |
|
Max |
Relative to the last section’s maximum edge. For example, Rel+0,Max+.25 would position the current section ¼ inch below the last section. (supports overflow) |
|
Mpg |
Relative to any section at the maximum edge. For example, Abs+0,Mpg+.25 places the current section ¼ inch below the lowest object currently on the page. (does not support overflow) |
|
T2T |
Top edge is placed relative to the last section’s top edge. (Similar to Rel) |
|
T2B |
Top edge is placed relative to the last section’s bottom edge. (Similar to Max+) |
|
B2T |
Bottom edge is placed relative to the last section’s top edge. (Similar to Max-) |
|
Bottom edge is placed relative to the last section’s bottom edge. |
|
|
L2L |
Left edge is placed relative to the last section’s left edge. (Similar to Rel) |
|
L2R |
Left edge is placed relative to the last section’s right edge. (Similar to Max+) |
|
R2L |
Right edge is placed relative to the last section’s left edge. (Similar to Max-) |
|
R2R |
Right edge is placed relative to the last section right edge. |
|
Ctr |
X/Y dimensions are centered on the last section’s X/Y dimensions. |
© Copyright 2012, Oracle and/or its affiliates. All rights reserved. Legal notices.