Specifies the timeout period
for the protection group in seconds. The timeout period is the longest time
Geographic Edition waits for a response after you run a geopg
as geopg start
, geopg stop
, geopg switchover
, and geopg takeover
. If the command does not respond within
the timeout period, the Geographic Edition software reports the operation as timed out,
even if the underlying command eventually completes successfully.
You should identify the amount of
time required to perform a role-reversal of the data replication, and set the
timeout value to 150% to 200% of that value to ensure enough time
for the role-reversal to complete.
To ensure that an operation has finished on the
remote cluster, check system status after a timeout before attempting the operation again. For
more information, see Troubleshooting Migration Problems.
The timeout period applies to operations on a per-cluster
basis. An operation with a local scope times out if the operation does
not complete after the specified timeout period.
An operation with a global scope consists
of an action on the local cluster and an action on the remote
cluster. The local and remote action are timed separately so that an operation
with a global scope times out during one of the following conditions:
This property can be tuned only when the protection group is offline.
Range: 20-1000000 seconds