Verifying the HA for Siebel Installation and Configuration

This section contains the procedure you need to verify that you installed and configured your data service correctly.

How to Verify the HA for Siebel Installation and Configuration

Use this procedure to verify that you installed and configured HA for Siebel correctly.

1. Bring the Siebel database, Siebel gateway, and Siebel server resources online on the cluster.
2. Log in to the node on which the Siebel server is online.
3. Confirm that the fault monitor functionality is working correctly.
4. Start srvrmgr and run the subcommand list compgrps.
5. Verify that the required Siebel components are enabled.
6. Connect to Siebel using a supported thin-client (browser) and run a session.
7. As user root, switch the Siebel server resource group to another node.

   # clresourcegroup switch -n node2 siebel-rg 

8. Repeat Step 4, Step 5, and Step 6 for each potential node on which the Siebel server resource can run.
9. As root user, switch the Siebel gateway resource group to another node.

   # clresourcegroup switch -n node2 gateway-rg