Configuring the Reader and the Edge for DDRs

These two configurations are very similar to those for PDR loads.

This procedure assumes that you have created a graph and added the UniversalDataReader component. It also assumes that you have added an Edge and also added the DDR source file to the project's data-in folder.

To configure the UniversalDataReader and Edge components:

  1. To configure the UniversalDataReader component for the DDR input file, use the same procedure as described in the topic Configuring the Reader for the PDR input file. The only difference is that you will be using your DDR file as the input file.
  2. To configure the Edge component, use the same procedure as described in the topic Configuring the Reader Edge. Be sure to use the Extract names and Reparse options on the Metadata Editor.
  3. When you have finished your configuration, save the graph.