This section describes the steps you must complete on the secondary cluster before you can configure SRDF data replication in Geographic Edition software.
Before You Begin
Before you can issue the SRDF commands on the secondary cluster, you need to create a RDF2 type device group on the secondary cluster that contains the same definitions as the RDF1 device group.
phys-paris-1# symdg export devgroup -f devgroup.txt -rdf
phys-paris-1# rcp devgroup1.txt phys-newyork-1:/. phys-paris-1# rcp devgroup1.txt phys-newyork-2:/.
Run the following command on each node in the newyork cluster.
# symdg import devgroup1 -f devgroup1.txt Adding standard device 054 as DEV001... Adding standard device 055 as DEV002...