Set the Boot Mode
The server is equipped with Unified Extensible Firmware Interface (UEFI), which supports both
Legacy BIOS and UEFI boot modes. Legacy BIOS Boot Mode is enabled by default.
Because the Windows Server 2012 and 2012 R2 operating systems support both Legacy BIOS
and UEFI, you have the option of setting the boot mode to either Legacy BIOS or UEFI before you
perform the OS installation.
Note -
After you have the installed the Windows Server operating system, if you decide you want to
switch from Legacy BIOS boot mode to UEFI boot mode, or vice versa, you must remove all partitions
and reinstall the operating system.
- Reset
or power on the server.
For example, do one of the following:
-
From the local server, press the Power button
(approximately 1 second) on the front panel of the server to turn the server off, then press the
Power button again to power on the server.
-
From the Oracle ILOM web interface, click Host Management
→ Power Control , select Reset from the Select Action list box, then click Save.
-
From the Oracle ILOM CLI, , type: reset
/System
The server begins the boot process and the BIOS screen appears.
Note -
The BIOS screen might take a while to appear. Please be patient.
Note -
The next events occur very quickly; therefore, focused attention is needed for the following
steps. Watch carefully for these messages as they appear on the screen for a brief time. You might
want to enlarge the size of your screen to eliminate scroll bars.
- When prompted in the BIOS screen, press the F2 key to access the BIOS Setup Utility.
After a few moments, the BIOS Setup Utility appears.
-
In the BIOS Setup Utility, use the arrow keys to navigate to the Boot menu.
The Boot menu screen appears.
Note -
The options in the boot order list differ depending on the storage drive configuration and
whether you have enabled the Persistent Boot Support feature. For more information about Persistent
Boot Support, refer to the
Oracle X5 Series Servers Administration Guide at
http://www.oracle.com/goto/x86AdminDiag/docs.
-
Use the down arrow key to select the UEFI/BIOS Boot Mode
field, and then press Enter.
-
Select your preferred boot mode, and then press Enter.
-
To save changes and exit BIOS, press the F10 key.
Note -
You must select the desired boot mode, Legacy BIOS or UEFI, before starting the operating
system installation.