| Execution Mode |
Specify the execution modes that this plug-in can run when invoked. For more information about execution modes, see "About Task Compensation".
Select one of the following:
-
Select Do to indicate that the automation should run during normal order processing. Deselect this check box and select Redo or Undo to restrict the automation to compensation processing only.
Note: If you select no check boxes on this tab, automation processing defaults to the Do execution mode.
-
Select Redo to indicate whether the automation should run again if the automation executed once but the order has changed since then.
-
Select Undo to indicate whether the action taken by an automation should be undone when the automation executed but the order has changed since then.
Note: Design Studio has validations in place that prevent you from defining more than one internal event receiver automation with the same execution mode per automated task or automated notification. For example, an automated task can not define two internal event receiver automations that both have Do selected for the execution mode. However, an automated task can define three internal event receiver automations if each defines a different execution mode (Do, Redo, and Undo).
|
