Front-Mounting a Tapped Hole Rack Installation

To install the stationary slide rails on the front of a tapped hole equipment rack:

1. Locate the following components:

   • 2 x stationary slide rail sections

   • 4 x 10-32 x 5/8” screws

   • 2 x mounting spacers

2. Line up the stationary slide rail end with three mounting slots with an appropriate mount point on the front of the equipment rack.
   

   Stationary Slide Rail Lined Up With Front Mount Point

3. Place 2 x 10-32 screws through the mounting spacer and through the stationary slide rail ear.
4. Screw in and secure the stationary slide rail to the equipment rack as shown in the following exploded view. Do not completely torque the screws; leave a small amount of play at this point.
   

   Screwing In and Securing the Stationary Slide Rail

5. Repeat Steps 3 and 4 for the other mounting point.
   

   Installed Stationary Slide Rail

6. Repeat this procedure for the other stationary slide. Your rack should resemble the following image.
   

   Installed Stationary Slide Rails