Rear-Mounting a Tapped Hole Rack Installation

To install the stationary slide rails on the rear of a tapped hole equipment rack:

1. Locate the following components:

   • 4 x 10-32 x 5/8” screws

2. Expand and line up the opposite end of the stationary slide rail on the outside of the rear rack slide rail at the same height used for the front mount point.
   

   Rear Mount Point

3. Place one 10-32 screw through the stationary slide rail ear and screw in place.
4. Repeat Step 3 for the other mounting point.
   

   Stationary Slide Rail Secured to Rear Mount Point

5. Your rack should resemble the following image.
   

   Rear-Mounted Stationary Slide Rails