Debugging HA for Oracle E-Business Suite up to Release 12.1

Language:

How to Turn on Debugging for HA for Oracle E-Business Suite up to Release 12.1

HA for Oracle E-Business Suite up to release 12.1 can be used by multiple Oracle E-Business Suite up to release 12.1 instances. It is possible to turn debugging on for all Oracle E-Business Suite up to release 12.1 instances or a particular Oracle E-Business Suite up to release 12.1 instance.

/opt/SUNWscebs/xxx/etc/config allows you to turn on debugging for all Oracle E-Business Suite up to release 12.1 instances or for a specific Oracle E-Business Suite up to release 12.1 instance on a particular node or zone within the cluster. If you require debugging to be turned on for HA for Oracle E-Business Suite up to release 12.1 across the whole cluster, repeat this step on all nodes within the cluster.

Edit the /etc/syslog.conf file.

Change daemon.notice to daemon.debug.

# grep daemon /etc/syslog.conf
*.err;kern.debug;daemon.notice;mail.crit        /var/adm/messages
*.alert;kern.err;daemon.err                     operator
#

Change the daemon.notice file to daemon.debug and restart the syslogd command.
Note that the following output, from grep daemon /etc/syslog.conf, shows that daemon.debug has been set.
```
# grep daemon /etc/syslog.conf
*.err;kern.debug;daemon.debug;mail.crit        /var/adm/messages
*.alert;kern.err;daemon.err                    operator
```

Restart the syslog daemon.

# svcadm disable system-log
# svcadm enable system-log

Edit the /opt/SUNWscebs/cmg/etc/config file.
Perform this step for each component that requires debug output, on each node of Oracle Solaris Cluster as required.

Edit the /opt/SUNWscebs/cmg/etc/config file and change DEBUG= to DEBUG=ALL or DEBUG=sun-cluster-resource.
```
# cat /opt/SUNWscebs/cmg/etc/config
#
# Copyright 2012Oracle and/or its afiiliates.  All rights reserved.
# Use is subject to license terms.
#
# ident "@(#)config     1.1     06/03/06"
#
# Usage:
#       DEBUG=<RESOURCE_NAME> or ALL
#
DEBUG=ALL
```
Note - To turn off debug, reverse the previous steps.