To recover from an error state, you might perform some or all of the steps in the following procedure.
If the recovery procedures change the state of the device group, this state is automatically detected by the resource and is reported as a new protection group state.
phys-paris-1# geopg validate protection-group
Specifies the name of the SRDF protection group.
If the geopg validate command determines if the configuration is valid, the state of the protection group changes to reflect that fact. If the configuration is not valid, geopg validate returns a failure message.
phys-paris-1# geopg list protection-group
Specifies the name of the SRDF protection group
phys-paris-1# geoadm status