This section contains the procedure you need to verify that you installed and configured your data service correctly.
Use this procedure to verify that you installed and configured HA for SAP liveCache correctly. You need the information in the following table to understand the various states of the liveCache database.
|
Oracle Solaris Cluster software restarts liveCache.
If you do not see this behavior, you might not have correctly performed Step 2 and Step 3 in How to Register and Configure HA for SAP liveCache.
# ps -ef|grep sap|grep kernel # kill -9 livecache-processes
Oracle Solaris Cluster software does not restart liveCache. However, the liveCache resource status message reflects that liveCache stopped outside of Oracle Solaris Cluster software through the use of the Stop liveCache button in LC10 or the lcinit command. The state of the liveCache resource is UNKNOWN. When the user successfully restarts liveCache by using the Start liveCache button in LC10 or the lcinit command, the HA for SAP liveCache Fault Monitor updates the resource state and status message to indicate that liveCache is running under the control of Oracle Solaris Cluster software.
If you do not see this behavior, you might not have correctly performed Step 2 and Step 3 in How to Register and Configure HA for SAP liveCache.
# clresourcegroup switch -n node2 livecache-resource-group
Terminate SAP xserver abnormally by stopping all SAP xserver processes.
# ps -ef|grep xserver # kill -9 xserver-process
Verify that the SAP xserver agent restarts the SAP xserver.